Electrical Receptacles - How to wire a receptacle?
Now you’re preparing for your receptacle wiring project. When working with electrical wiring, be sure to:
Turn off the circuit that you will be working on. Find the right breaker in the breaker box and turn it to the "Off" position. If you’re not so sure how to do it then turn the main power off and lock the electrical panel, someone else may accidentally turn the power back on while you are wiring. If still in doubt, look for a reliable electrician.
Using circuit tester to make sure the power is off.
Be sure to check local codes for proper installation and permits.
What you’re looking for is replacing an old receptacle and installs a new one. Then you just simply pay close attention when disconnecting the wire and see how the old receptacle is wired, remove it and re-wire the new one in exact the same position. Please see the wiring diagram down below this page
RECEPTACLES are used to plug in lights and appliances around the building.
Types of receptacles:
What are the Code requirements for installing a receptacle?
Receptacles shall be listed and marked with the manufacturer's name, voltage and ampere ratings. Receptacles and cord connectors shall be rated not less than 15 amperes, 125 volts.
Ground Fault Circuit Interrupters (GFCI) are required where replacements are made at receptacle outlets.
How do you select the wire size?
You will not want to exceed the amperage rating,for example,if the maximum amperage rating is 20A, a #12 wire gauge would be recommended. Always check with your local building authorities for wire sizing requirements in your area. Receptacle wiring diagram
